Squib Circuit Inspection
- Ignition switch "OFF".
- Disconnect (-) terminal cable from battery and wait for 1 minutes or more.
- Remove the DCAB connector and connect the dummy and dummy adapter to the DCAB connector.CAUTION: If dummy and dummy adaptor are not able to be prepared, use a known-good DCAB or 2Ω resistor.
- Connect (-) terminal cable to battery and Ignition switch "ON" & Engine "OFF" and wait for 30 seconds or more.
- Connect KDS to Data Link Connector (DLC) and clear DTC with KDS and diagnose again.
- Is any DTC present?
YES
- Go to "MAIN HARNESS CIRCUIT INSPECTION " procedure.
NO
- If no problems were found with the circuits or connectors, Replace the DCAB and go to "VERIFICATION OF VEHICLE REPAIR " procedure.