LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Sedona EX >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (2 Of 3) >> DTC B1384-00: Side Airbag Front-Passenger Resistance Circuit Short To Ground >> Wiring Inspection >> Squib Circuit Inspection

Squib Circuit Inspection

  1. Ignition switch "OFF".
  2. Disconnect battery (-) cable and wait at least for one minute.
  3. Remove the side airbag front-passenger and connect the dummy and dummy adaptor to side airbag front-passenger harness connector.
    CAUTION: If dummy and dummy adaptor are not able to be prepared, use a known-good Driver Airbag or 2Ω resistor.
  4. Connect battery (-) cable and turn the ignition switch "ON" and wait for 30 sec.
  5. Connect KDS to Data Link Connector (DLC) and clear DTC with KDS and run the diagnostics again.
  6. Has any DTCs stored in the system?

    YES 

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • If problem still occurs, replace Side Airbag Front-Driver and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals