Component Inspection

WARNING: This page is about a different variant/trim than selected.

Ignition "OFF"
Disconnect Battery (-) terminal.
Refer to "INPUT SPEED SENSOR " and disconnect input speed sensor connector.
Measure resistance between Pin No. 4 (Power) terminal and Pin No. 5 (Signal) terminal of input speed sensor.
Specification: Approx. 2.7MΩ
Is measured value within specification?
YES
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace Input Speed Sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.