Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF"
- Refer to "GEAR ACTUATOR ASSEMBLY " and disconnect Gate Select Actuator connector.
- Measure resistance between Pin No. 15 (Ground) terminal of Gate Select Actuator harness connector and chassis ground.
Specification: Approx. below 1Ω
- Is measured value within specification?
YES
- Go to "SHIELD GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in ground circuit between Gate Select Actuator and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.