LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima SX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Dual Clutch Transmission Diagnosis - 1.6L (2 Of 2) (Except HEV)) >> DTC P0955-29: Manual Mode Switch >> Wiring Inspection >> CAN Communication Line Inspection

CAN Communication Line Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition "ON"
  2. Measure voltage between Pin No. 5 (CCP-CAN High) terminal of Sport mode switch and chassis ground.
  3. Measure voltage between Pin No. 4 (CCP-CAN Low) terminal of Sport mode switch and chassis ground.

    Specification:  CAN High Voltage - Approx. 3.28V/CAN Low Voltage - Approx. 1.87V

  4. Is measured value within specification?

    YES 

    NO 

    • Repair short in CCP-CAN Communication circuit or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
scientia non olet · About LEMON Manuals