Solenoid Push Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Ignition "OFF"
Refer to "GEAR ACTUATOR ASSEMBLY " and disconnect Gate Select Actuator connector.
Ignition "ON"
Measure voltage between Pin No. 7 (Solenoid Push) terminal of Gate Select Actuator harness connector and chassis ground.
Specification: Approx. 3.7V
Is measured value within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in power circuit between Gate Select Actuator and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.