LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima SX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Dual Clutch Transmission Diagnosis - 1.6L (2 Of 2) (Except HEV)) >> DTC P0904-12: Select 1 Position Sensor Short To Battery >> Wiring Inspection >> Shield Ground Circuit Inspection

Shield Ground Circuit Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition "OFF"
  2. Refer to "GEAR ACTUATOR ASSEMBLY and DCT CONTROL MODULE (TCM) " disconnect Gate Select Actuator/TCM connector.
  3. Measure resistance between Pin No. 5 (Signal) terminal of Gate Select Actuator harness connector and Pin No. 26 (Signal) terminal of TCM harness connector.

    Specification:  Approx. below 1Ω

  4. Is measured value within specification?

    YES 

    • If problem still occurs, replace "Gate Select Actuator" and then go to "VERIFICATION OF REPAIR " procedure.

    NO