Power Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Ignition "OFF"
Refer to "DCT CONTROL MODULE (TCM) " and disconnect TCM connector.
Ignition "ON"
Measure voltage between Pin No. 65, 66, 17 (Power) terminal of TCM harness connector and chassis ground.
Specification: Approx. B+
Is measured value within specification?
YES
- If problem still occurs, replace "TCM" and then go to "VERIFICATION OF REPAIR " procedure.
NO
- Check the related "FUSE". Check for open/short in harness. Repair as necessary and Go to "VERIFICATION VEHICLE REPAIR " procedure.