Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF"
- Refer to "SHIFT LEVER " and disconnect TGS Lever Sensor connector.
- Measure resistance between Pin No. 6 (Ground) terminal of TGS Lever Sensor harness connector and chassis ground.
Specification: Approx. below 1Ω
- Is measured value within specification?
YES
- Go to "CAN COMMUNICATION LINE INSPECTION " procedure.
NO
- Repair open or short in ground circuit between TGS Lever Sensor and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.