LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima SX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Dual Clutch Transmission Diagnosis - 1.6L (2 Of 2) (Except HEV)) >> DTC P0820-08: TGS Lever Complement Value >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn Ignition "OFF" and then "ON"
  2. Monitor "Diagnostic Trouble Codes (DTC)" with KDS.
  3. Clear all DTCs in the system with KDS.
  4. Re-check DTC in the system with KDS.
  5. Repeat above procedure few times.
  6. Are any DTCs stored in the system?

    YES 

    • Carefully re-do this troubleshooting guide steps.
    • If problem still occurs, replace TGS Lever Sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals