DTC Index
WARNING: This page is about a different variant/trim than selected.
DTC INDEX
| DTC | Description |
|---|---|
| DTC P0805 | 64: Clutch 1 Motor Hall Sensor circuit |
| DTC P0820 | 08: TGS Lever Complement Value |
| DTC P0820 | 16: TGS Lever Under Voltage |
| DTC P0820 | 17: TGS Lever Over Voltage |
| DTC P0820 | 1C: TGS Lever Voltage Out of Range |
| DTC P087A | 64: Clutch 2 Motor Hall Sensor Circuit |
| DTC P0880 | 1C: TCM Power Input |
| DTC P0900 | 01: Clutch 1 Motor U/V/W Circuit |
| DTC P0901 | 71: Clutch 1 System Actuator Stuck |
| DTC P0901 | 73: Clutch 1 System System Stuck Off |
| DTC P0901 | 78: Clutch 1 System Reference Position Failure |
| DTC P0901 | 7F: Clutch 1 System System Stuck Off |
| DTC P0904 | 12: Select 1 Position Sensor Short to Battery |
| DTC P0904 | 14: Select 1 Position Sensor Short to Ground/Open |
| DTC P090A | 01: Clutch 2 Motor U/V/W Circuit |
| DTC P090B | 71: Clutch 2 System Actuator Stuck |
| DTC P090B | 73: Clutch 2 System System Stuck Off |
| DTC P090B | 78: Clutch 2 System Reference Position Failure |
| DTC P090B | 7F: Clutch 2 System System Stuck Off |
| DTC P0910 | 11: Select 1 Solenoid Push/Pull Short to Ground |
| DTC P0910 | 12: Select 1 Solenoid Push/Pull Short to Battery |
| DTC P0910 | 13: Select 1 Solenoid Push/Pull Open |
| DTC P0910 | 15: Select 1 Solenoid LSD Short to Battery |
| DTC P0914 | 64: Shift 1 Motor Hall Sensor Circuit |
| DTC P0920 | 01: Shift 1 Motor U/V/W Circuit |
| DTC P0921 | 77: Gear 1 System Referencing Failure |
| DTC P0921 | 98: Gear 1 System Motor Thermal Damage |
| DTC P0955 | 29: Manual Mode Switch |
| DTC P17C0 | 00: DCT None-EOL |
| DTC P1904 | 12: Select 2 Position Sensor Short to Battery |
| DTC P1904 | 14: Select 2 Position Sensor Short to Ground/Open |
| DTC P1910 | 11: Select 2 Solenoid Push/Pull Short to Ground |
| DTC P1910 | 12: Select 2 Solenoid Push/Pull Short to Battery |
| DTC P1910 | 13: Select 2 Solenoid Push/Pull Open |
| DTC P1910 | 15: Select 2 Solenoid LSD Short to Battery |
| DTC P1914 | 64: Shift 2 Motor Hall Sensor Circuit |
| DTC P1920 | 01: Shift 2 Motor U/V/W Circuit |
| DTC P1921 | 77: Gear 2 System Referencing Failure |
| DTC P1921 | 98: Gear 2 System Motor Thermal Damage |
| DTC P2765 | 12: Input Speed Sensor 2 Short to Battery |
| DTC P2765 | 14: Input Speed Sensor 2 Short to Ground/Open |
| DTC P2766 | 03: Input Speed Sensor 2 Circuit Range/Performance (Invalid Pulse Width) |
| DTC P2766 | 31: Input Speed Sensor 2 Circuit Range/Performance (No Pulse) |
| DTC U0001 | 88: CAN Communication Bus Off |
| DTC U0100 | 87: Lost Communication With ECM/PCM |
| DTC U0121 | 87: Lost Communication With Anti-Lock Brake System (ABS) Control Module |
| DTC U1100 | 87: High Speed CAN2 Lost Communication (EMSDCT) |
| DTC U1103 | 41: Check Sum Error with TGS Lever |
| DTC U1103 | 82: TGS Lever Alive Counter Error |
| DTC U1103 | 87: Lost Communication With TGS Lever |
| DTC U1117 | 88: High Speed CAN2 Communication (EMS-DCT) |