LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima SX >> Repair and Diagnosis >> External Pages >> Different car >> Section 553 (Double Clutch Transmission Diagnosis - 1.6L (1 Of 4)) >> DTC P0705-29: Inhibitor Switch Invalid Code >> DTC Inspection >> Shift Cable Inspection

Shift Cable Inspection

WARNING: This page is about a different car, the 2022 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition 

  1. Shift gear lever to "N".
  2. Check the matching of the manual control lever and inhibitor switch "N" position.
  3. "N" position check procedure
    • Insert the jig ( 5) to the "N" position setting hole.

    When you insert the jig, there shall be no such strain/jam between manual control lever and cable lever.

  4. If the strain or jam occur, remove the shift cable nut and adjust the position of inhibitor switch.
  5. Remove the jig from the "N" position setting hole.
  6. Shift gear lever from "P" to "D" after procedure completion two times.

    Good 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.

    No Good 

scientia non olet · About LEMON Manuals