Circuit Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Control circuit (Open/Short): Voltage | Approx. 3.7V |
|
Select solenoid 1 Pull terminal | Chassis ground |
| Control circuit (Open/Short): Voltage | Approx. 3.7V |
|
Select solenoid 1 Push terminal | Chassis ground |
| Ground circuit (Open): Resistance | Approx. below 1Ω |
|
Select solenoid 1 ground terminal | Chassis ground |
| Shield ground circuit (Open): Resistance | Approx. below 1Ω |
|
Select solenoid 1 shield ground terminal | Chassis ground |
- Is the result within specifications?
YES
- This can be an intermittent fault caused by poor contact in the sensor's and/or control module's connector. Or, control module's memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage.
- Replace the select actuator with an usable one and check for proper operation. If it works properly, put the component in place. Then, go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Repair the control circuit with an open or short. Then, go to "VERIFICATION OF VEHICLE REPAIR ".