LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima LX >> Repair and Diagnosis >> External Pages >> Different car >> Section 572 (Double Clutch Transmission Diagnosis - 1.6L (3 Of 4)) >> DTC P0910-13: Select 1 Solenoid Push/Pull Open >> Wiring Inspection >> Circuit Inspection

Circuit Inspection

WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
G13505591Courtesy of KIA MOTORS AMERICA, INC.
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Disconnect the electrical connector(s) from the concerned component.
  2. Ignition "ON".
 Gear actuator assembly connector 2 (power) Chassis ground - B+
  1. Ignition "OFF".
  2. Disconnect battery (-) cable.
  3. Disconnect the electrical connector(s) from the concerned component.
 Gear actuator assembly connector 6 (L1) Chassis ground - Approx. below 1Ω
  1. Ignition "ON".
 Gear actuator assembly connector 3 (CAN3 high) Gear actuator assembly connector 4 (CAN3 low) Fig.1
Gear actuator assembly connector 5 (CAN4 high) Gear actuator assembly connector 6 (CAN4 low)
  1. Disconnect the electrical connector(s) from the concerned component.
  2. Ignition "ON".
 Gear actuator assembly connector 3 (CAN3 high) Gear actuator assembly connector 4 (CAN3 low) Fig.2
Gear actuator assembly connector 5 (CAN4 high) Gear actuator assembly connector 6 (CAN4 low)
G13505592Courtesy of KIA MOTORS AMERICA, INC.
G13505593Courtesy of KIA MOTORS AMERICA, INC.

Good 

No Good 

scientia non olet · About LEMON Manuals