Solenoid Pull Circuit Inspection
- Ignition "OFF"
- Refer to "GEAR ACTUATOR ASSEMBLY "and disconnect Gate Select Actuator connector.
- Ignition "ON"
- Measure voltage between Pin No. 14 (Solenoid Pull) terminal of Gate Select Actuator harness connector and chassis ground.
Specification: Approx. 3.7V
- Is measured value within specification?
YES
- Go to "SOLENOID PUSH CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in power circuit between Gate Select Actuator and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.