L2 (V) Circuit Inspection
- Ignition "OFF"
- Refer to "GEAR ACTUATOR ASSEMBLY " and disconnect Gear Shift Actuator connector.
- Ignition "ON"
- Measure voltage between Pin No. 16 (L2) terminal of Gear Shift Actuator harness connector and chassis ground.
Specification: Approx. 0.6V
- Is measured value within specification?
YES
- Go to "L3 (W) CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in circuit between Gear Shift Actuator and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.