Shield Ground Circuit Inspection
- Ignition "OFF"
- Refer to "GEAR ACTUATOR ASSEMBLY " and disconnect Gate Select Actuator connector.
- Measure resistance between Pin No. 6 (Ground) terminal of Gate Select Actuator harness connector and chassis ground.
Specification: Approx. below 1Ω
- Is measured value within specification?
YES
- If problem still occurs, replace "Gate Select Actuator" and then go to "VERIFICATION OF REPAIR " procedure.
NO
- Repair open or short in ground circuit between Gate Select Actuator and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.