LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima EX Premium >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Dual Clutch Transmission Diagnosis - 1.6L (2 Of 2) (Except HEV) >> DTC P0910-11: Select 1 Solenoid Push/Pull Short To Ground >> DTC Inspection >> Monitor KDS Data

Monitor KDS Data

  1. Connect KDS to Data Link Connector (DLC).
  2. Engine "ON"
  3. Operate vehicle or system in accordance with Enable Condition in DTC Detecting Condition.
  4. Move selector lever from "P" range to "D" range. And Driving at 1st gear to 7th gear.
  5. Monitor "Shift Motor 1, 2 position" parameter in "Current Data" with KDS.

    Specification:  Refer to Figure below

    G12937165Courtesy of KIA MOTORS AMERICA, INC.
    G12937166Courtesy of KIA MOTORS AMERICA, INC.
    G12937167Courtesy of KIA MOTORS AMERICA, INC.
    G12937168Courtesy of KIA MOTORS AMERICA, INC.
    G12937169Courtesy of KIA MOTORS AMERICA, INC.
    G12937170Courtesy of KIA MOTORS AMERICA, INC.
    G12937171Courtesy of KIA MOTORS AMERICA, INC.
  6. Is measured value within specification?

    YES 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals