LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima EX Premium >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Dual Clutch Transmission Diagnosis - 1.6L (2 Of 2) (Except HEV) >> DTC P090A-01: Clutch 2 Motor U/V/W Circuit >> DTC Inspection >> Monitor KDS Data

Monitor KDS Data

  1. Connect KDS to Data Link Connector (DLC).
  2. Engine "ON"
  3. Operate vehicle or system in accordance with Enable Condition in DTC Detecting Condition.
  4. Move selector lever from "P" range to "D" range. And Driving at 1st gear to 7th gear.
  5. Monitor "Shift Motor 1, 2 position" parameter in "Current Data" with KDS.

    Specification:  Refer to Figure below

    G12937094Courtesy of KIA MOTORS AMERICA, INC.
    G12937095Courtesy of KIA MOTORS AMERICA, INC.
    G12937096Courtesy of KIA MOTORS AMERICA, INC.
    G12937097Courtesy of KIA MOTORS AMERICA, INC.
    G12937098Courtesy of KIA MOTORS AMERICA, INC.
    G12937099Courtesy of KIA MOTORS AMERICA, INC.
    G12937100Courtesy of KIA MOTORS AMERICA, INC.
  6. Is measured value within specification?

    YES 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals