Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
- Installation is in the reverse order of removal.
- Refill a radiator and a reservoir tank with engine coolant.
(Refer to COOLANT )
- Charge with refrigerant.
- Refill engine with engine oil.
(Refer to ENGINE OIL )
- Refill a transaxle with fluid.
- Align headlamps, see REPAIR PROCEDURES .
- Align the advanced smart cruise control sensor.
- Clean battery posts and cable terminals and assemble.
- Inspect for fuel leakage.
- After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
- Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.