Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.

Connect the KDS to the vehicles data link connector (DLC).
Check any DTCs and if exist, repair according to the DTC guide.
Check the power supply voltage provided to the fuel pressure sensor (FPS).
Specification: 5V

Courtesy of KIA MOTORS AMERICA, INC.
Check the voltage provided to the fuel pressure sensor (FPS) at idle.
Specification: 1.9-3.2 V

Courtesy of KIA MOTORS AMERICA, INC.
Check the fuel pressure in the low fuel line.
(Refer to Fuel Delivery System - "FUEL PRESSURE TEST ")

Items	Specification
start	Max. 600 KPa (Max. 6.1 kgf/cm² , Max. 87.0 psi)
In operation	350 - 500 KPa (3.5 - 5.1 kgf/cm² , 50.7 - 72.5 psi)