Throttle Position Sensor (TPS)
WARNING: This page is about a different variant/trim than selected.
- Connect the KDS on the Data Link Connector (DLC).
- Start the engine and measure the output voltage of TPS 1 and 2 at C. T. and W.O. T.
TPS OUTPUT VOLTAGE SPECIFICATION
| Throttle Angle (°) | Output Voltage (V) [Vref = 5V] | |
|---|---|---|
| TPS1 | TPS2 | |
| 0 | 0.0 | 5.0 |
| 10 | 0.48 | 4.52 |
| 20 | 0.95 | 4.05 |
| 30 | 1.43 | 3.57 |
| 40 | 1.90 | 3.10 |
| 50 | 2.38 | 2.62 |
| 60 | 2.86 | 2.14 |
| 70 | 3.33 | 1.67 |
| 80 | 3.81 | 1.19 |
| 90 | 4.29 | 0.71 |
| 100 | 4.76 | 0.24 |
| 105 | 5.0 | 0 |
| C. T (6 - 15°) | 0.29 - 0.71 | 4.29 - 4.71 |
| W.O. T (93 - 102°) | 4.43 - 4.86 | 0.14 - 0.57 |