Repair Procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

Fig 1: Locating Crash Pad Side Cover (RH)
Courtesy of KIA MOTORS AMERICA, INC.
Loosen the glove box housing mounting bolts (A).

Fig 2: Locating Glove Box Housing Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the glove box housing (A) by using a screw driver.

Fig 3: Locating Glove Box Housing With Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the glove box lamp connector (A).

Fig 4: Locating Glove Box Lamp Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the glove box housing mounting clip (A).

Fig 5: Locating Glove Box Housing Mounting Clip
Courtesy of KIA MOTORS AMERICA, INC.

Information
- When installing glove box housing, be sure to insert lock pin (A) into wiring tape (B).
Fig 6: Locating Lock Pin And Wiring Tape
Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information
- Make sure the connector are connected in properly.
- Replace any damaged clips.