DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Internal monitoring	UART communication error Open/short in temperature sensor Open/short in charging coil
Enable Condition	ACC "ON"
Threshold Value	Not initialized communication or Checksum mismatch between the MCU and the Charging Controller The voltage of temperature sensor lower than 0.2V or higher than 4.8V Charging coil current is abnormal * If any one of the above case occur, it is determined as failure
Detection Time	Charging controller error: 1000 ms Temperature sensor error: 150 ms Transmitting coil error: 150 ms
Recovery Condition	Fault cleared