LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Optima S >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (3 Of 3) (Except HEV) >> DTC B2500-00: Warning lamp Failure >> Wiring Inspection >> CAN Register and Communication Line Inspection >> ■ CAN Register and Communication Line Inspection 2

■ CAN Register and Communication Line Inspection 2

  1. Ignition "OFF".
  2. Disconnect ECM/PCM and CLU main harness connector.
  3. Measure resistance between Pin No. 85 (High) terminal and Pin No. 63 (Low) terminal of ECM. (GAMMA 1.6 T-GDI)
  4. Measure resistance between Pin No. 77 (High) terminal and Pin No. 60 (Low) terminal of PCM. (THETA-II 2.0 T-GDI)
  5. Measure resistance between Pin No. 77 (High) terminal and Pin No. 60 (Low) terminal of PCM. (THETA-II 2.4 GDI)
  6. Measure resistance between Pin No. 32 (High) terminal and Pin No. 33 (Low) terminal of CLU.

    Specification:  About 120 Ω

  7. Is the measured resistance within specification?

    YES 

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • Problem still occurs, replace, ECM/PCM or CLU and then go to, "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals