LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Sorento L >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electronic Parking Brake Diagnosis >> DTC C1616-08: C-Can Bus Off >> Wiring Inspection >> CAN Communication Circuit Inspection >> Inspection Procedure For Resistance Measurement

Inspection Procedure For Resistance Measurement

When measuring impedance, it is generally necessary to disconnect the circuit being tested from the power supply before hand. The vehicle's battery should therefore be disconnected and wait about four minutes to allow all capacitors in the system to discharge.

Inspection procedure for resistance test:

  1. The CAN bus must be disconnected from the power supply.
  2. The measurement is taken between the CAN High and CAN Low leads.
  3. The measurement recorded may differ from the specified levels by a few ohms.
scientia non olet · About LEMON Manuals