LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Sorento L >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electronic Parking Brake Diagnosis >> DTC C1604-04: ECU Hardware Error >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Engine "ON".
  3. Monitor "Current (RH) - Cable" parameters in "Current Data" with GDS.

    Specification  : Non-control condition: Approx. 0 A

    Fig 1: Screen Display - Current (RH) - Cable Parameters In Current Data With GDS
    G12174924Courtesy of KIA MOTORS AMERICA, INC.
  4. Is parameter displayed within specification?

    YES 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals