LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Sorento L >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electronic Parking Brake Diagnosis >> DTC C1501-01: Switch Failure >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Engine "ON".
  3. Operate EPB Switch
  4. G Monitor "Apply Switch" and "Release Switch" parameters in "Current Data" with GDS.

    Specification  : On EPB Applying: Apply Switch "ON"/On EPB Releasing: Release Switch "ON"

    Fig 1: Apply Switch & Release Switch Parameters In Current Data With GDS
    G12174913Courtesy of KIA MOTORS AMERICA, INC.
  5. Is parameter displayed within specification?

    YES 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

    NO 

scientia non olet · About LEMON Manuals