LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Sorento L >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electronic Parking Brake Diagnosis >> DTC C1241-02: Force Sensor Failure >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Engine "ON".
  3. EPB Switch "ON".
  4. Monitor "Sensor (not supported Caliper type)" parameter on "Current Data" with GDS.

    Specification  : Refer to Fig 1 below

    Fig 1: Sensor (Supported Caliper Type) Parameter On Current Data With GDS
    G12174908Courtesy of KIA MOTORS AMERICA, INC.
  5. Is parameter displayed within specification?

    YES 

    • Fault is intermittent caused by poor contact in the EPB ECU's connector or was repaired and EPB ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace EPB ECU and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals