Component Inspection

Ignition "OFF"
Disconnect the battery (-) cable and wait at least for one minute.
Refer to SIDE IMPACT SENSOR (SIS) and remove Pressure Side Impact Sensor-Passenger.
Measure resistance between Pin No. 1 (High) terminal and Pin No. 2 (Low) terminal of Pressure Side Impact Sensor-Passenger.
Specification: Approx. 2.5MΩ (Actual Vehicle Test value)

Fig 1: Screen Display - KDS/GDS Multimeter Resistance Check
Courtesy of KIA MOTORS AMERICA, INC.
Is the measured resistance within specifications?
YES
- Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace SRSCM main harness and then go to "Verification of Vehicle Repair " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace Pressure Side Impact Sensor-Passenger and then go to "Verification of Vehicle Repair " procedure.