LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Optima SX Limited >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (1 Of 2) (Except HEV) >> DTC B1380-00: Side Airbag Front-Driver Resistance Circuit Short To Ground >> DTC Inspection >> Monitor KDS/GDS Data

Monitor KDS/GDS Data

  1. Ignition "OFF", connect KDS/GDS.
  2. Ignition "ON", select "Current Data  " mode.
  3. Monitor the "Drive SAB resistance" parameter on the KDS/GDS.

    Specification: 

    Resistance of Side airbag front-Driver greater than 1.0Ω

    Resistance of Side airbag front-Driver less than 7.0Ω

    Reference: 

    In a case of an open in the Side airbag front-Driver circuit: FAIL

    In a case of a short to battery in the Side airbag front-Driver circuit: FAIL

    In a case of a short to ground in the Side airbag front-Driver circuit: FAIL

    Fig 1: Monitoring Drive SAB Resistance Parameter On KDS/GDS (Normal Data)
    G12137009Courtesy of KIA MOTORS AMERICA, INC.
  4. Is parameter displayed within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

    NO 

scientia non olet · About LEMON Manuals