Monitor KDS/GDS Data
- Ignition "OFF", connect KDS/GDS.
- Ignition "ON", select "Current Data " mode.
- Monitor the "Drive Pretensioner resistance" parameter on the KDS/GDS.
Specification:
Drive Pretensioner resistance greater than 1.0Ω
Drive Pretensioner resistance less than 7.0Ω
Reference:
In a case of an open in the Pretensioner Front-Driver circuit: FAIL
In a case of a short to battery in the Pretensioner Front-Driver circuit: FAIL
In a case of a short to ground in the Pretensioner Front-Driver circuit: FAIL
- Is parameter displayed within specifications?
YES
- Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
NO
- Go to "Wiring Inspection " procedure.