Component Inspection

Ignition "OFF"
Disconnect the battery (-) terminal cable from the battery, and wait at least one minute.
Refer to FRONT IMPACT SENSOR (FIS) and remove Front Impact Sensor (FIS) -Driver.
Measure resistance between Pin No. 2 (Low) terminal and Pin No. 1 (High) terminal of Front Impact Sensor (FIS) -Driver.
Specification: Approx. 2.5 MΩ (Actual Vehicle Test value)

Fig 1: Screen Display - KDS/GDS Multimeter Resistance Check
Courtesy of KIA MOTORS AMERICA, INC.
Is the measured resistance within specifications?
YES
- Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace SRSCM main harness and then go to "Verification of Vehicle Repair " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace Front Impact Sensor (FIS) -Driver and then go to "Verification of Vehicle Repair " procedure.