Component Inspection
PRESSURE SIDE IMPACT SENSOR-PASSENGER SPECIFICATION
| Inspection Condition |
(+) Probe |
(-) Probe |
Specification |
| Connector |
Terminal |
Connector |
Terminal |
- Ignition "OFF"
- Disconnect the auxiliary battery (-) cable and wait for one minute.
- Remove pressure side Impact sensor-passenger.
|
Pressure side Impact sensor-passenger |
2 (High) |
Pressure side Impact sensor-passenger |
1 (Low) |
Approx. 2.5 MΩ |
| Good |
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace SRSCM main harness and then go to "VERIFICATION OF REPAIR " procedure
|
| No Good |
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace pressure side impact sensor-Passenger and then go to "VERIFICATION OF REPAIR " procedure.
|