Main Harness Circuit Inspection

ANCHOR PRETENSIONER FRONT-DRIVER HARNESS CONNECTOR SPECIFICATION

Main Harness Circuit Inspection
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the auxiliary battery (-) cable and wait for one minute. Disconnect anchor pretensioner front-driver connector. Ignition "ON", engine "OFF"	Anchor pretensioner front-driver harness connector	1 (High)	Chassis ground	-	Figure
	Anchor pretensioner front-driver harness connector	2 (Low)	Chassis ground	-	Figure

Fig 1: Screen Display - Signal Waveform (Low & High) Of Anchor Pretensioner Front-Driver (Connector Disconnected)

G12331395

Courtesy of KIA MOTORS AMERICA, INC.

Good	Carefully re-do this troubleshooting guide steps. If problem still occurs, replace SRSCM and then go to "VERIFICATION OF REPAIR " procedure.
No Good	Carefully re-do this troubleshooting guide steps. If problem still occurs, replace SRSCM main harness and then go to "VERIFICATION OF REPAIR " procedure.