Main Harness Circuit Inspection
ANCHOR PRETENSIONER FRONT-DRIVER HARNESS CONNECTOR SPECIFICATION
| Main Harness Circuit Inspection |
| Inspection Condition |
(+) Probe |
(-) Probe |
Specification |
| Connector |
Terminal |
Connector |
Terminal |
- Ignition "OFF".
- Disconnect the auxiliary battery (-) cable and wait for one minute.
- Disconnect anchor pretensioner front-driver connector and SRSCM main harness connector.
|
Anchor pretensioner front-driver harness connector |
1 (High) |
Chassis ground |
- |
∞ (Infinite)Ω |
| Anchor pretensioner front-driver harness connector |
2 (Low) |
Chassis ground |
- |
∞ (Infinite)Ω |
| Good |
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace SRSCM and then go to "VERIFICATION OF REPAIR " procedure.
|
| No Good |
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace SRSCM main harness and then go to "VERIFICATION OF REPAIR " procedure.
|