CAN Resistance Inspection

INSPECTION PART - IBAU CIRCUIT INSPECTION

Inspection Part: CAN Resistance Inspection
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF" and disconnect the battery. Wait about four minutes. Disconnect the electrical connector(s) from the concerned component.	IBAU Connector	38 (C-CAN High)	IBAU Connector	39 (C-CAN Low)	Approx. 60Ω

Good	Go to "COMPONENT INSPECTION " procedure.
No Good	Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.