IBAU Circuit Inspection

INSPECTION PART - IBAU CIRCUIT INSPECTION

Inspection Part: IBAU Circuit Inspection
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	IBAU Connector	1 (power)	Chassis ground	-	B+
		30 (power)		-	B+
		5 (ON/START input)		-	B+
		14 (ground)		-	Below 1Ω
		46 (ground)		-	Below 1Ω

Good	Go to "COMPONENT INSPECTION " procedure.
No Good	Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.