DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	CAN message monitoring	Poor connector connection Short or open in P-CAN line between IBAU and ECM Faulty ECM
Enable Condition	Ignition "ON"
Threshold Value	Monitoring the error of AVSM in EMS message during driving without CAN hardware error and CAN bus off (The monitoring starts 1.5s after Ignition "ON") * Specific times control in progress: 50 times no control: 60 times
Warning Lamp	-
Disable Condition	Ignition "OFF" and then "ON"