Component Inspection

INSPECTION PART - FRONT WHEEL SENSORS LH INSPECTION

Inspection Condition	(+) Probe				Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component.	Front Wheel Sensor LH (Component Side)	1 (signal)	Front Wheel Sensor LH (Component Side)	2 (power)	Approx. 453.9kΩ

Good	Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
No Good	Carefully re-do this troubleshooting guide steps. If no problems were found with the circuits or connectors, replace the Wheel Speed Sensor ELECTRONIC STABILITY PROGRAM (ESP) SYSTEM and go to "VERIFICATION OF REPAIR " procedure.