Repair Procedures: Replacement

Information 

• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
• Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
• Take care not to bend or scratch the trim and panels.

1. Disconnect the stopper (B) from the glove box (A).
   Fig 1: Disconnect Stopper From Glove Box

   Courtesy of KIA MOTORS AMERICA, INC.
2. Disconnect the air damper (A) from the glove box (B).
   Fig 2: Disconnect Air Damper From Glove Box

   Courtesy of KIA MOTORS AMERICA, INC.
3. Using a screwdriver or remover, remove the crash pad side cover [RH] (A).
   Fig 3: Locating Crash Pad Side Cover (RH)

   Courtesy of KIA MOTORS AMERICA, INC.
4. After loosening the mounting screws and bolts, remove the glove box housing (A).
   Fig 4: Locating Glove Box Housing With Screws

   Courtesy of KIA MOTORS AMERICA, INC.
5. Install in the reverse order of removal.

Information 

• Make sure that the connectors are connected properly.
• Replace any damaged clips.