Repair Procedures: Replacement

Information 

• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
• Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
• Take care not to bend or scratch the trim and panels.

1. Using a screwdriver or remover, remove the crash pad side cover [LH] (A).
   Fig 1: Locating Crash Pad Side Cover With Clips (LH)

   Courtesy of KIA MOTORS AMERICA, INC.
2. After loosening the mounting screws, remove the crash pad lower panel (A).
   Fig 2: Locating Crash Pad Lower Panel With Screws

   Courtesy of KIA MOTORS AMERICA, INC.
3. Disconnect the diagnosis connector (A) and crash pad under lamp connector (B).
   Fig 3: Locating DLC & Crash Pad Under Lamp Connectors

   Courtesy of KIA MOTORS AMERICA, INC.
4. Install in the reverse order of removal.

Information 

• Make sure that the connectors are connected properly.
• Replace any damaged clips.