Resistance Measurement With Matching Resistor

Ignition "OFF" and disconnect the battery and wait about four minutes.
Make sure all modules are properly connected.
Measure resistance between Pin No. 5 (C-CAN High) and Pin No. 4 (C-CAN Low) terminal of IGPM harness connector.
Specification: Approx. 60 Ω
Is the measured value within specification?
YES
- Go to "CAN Signal Inspection" procedure.
NO
- If the value is out of specification then, go to "CAN RESISTOR INSPECTION " procedure.
  * If the measured value is approx. 0Ω, then check for short CAN communication line.
  
  * If the measured value is approx. ∞Ω, then check for open CAN communication line.