Glove Box Replacement

CAUTION:

A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad side cover (A).

Fig 1: Locating Crash Pad Side Cover
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the pins (A) and then remove the glove box (B).

Fig 2: Removing Glove Box
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the glove box housing (A).

Fig 3: Locating Glove Box Housing
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the glove box lamp connector (A).

Fig 4: Locating Glove Box Lamp Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damage clips.