Crash Pad Lower Panel Replacement

CAUTION:

A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad side cover (A).

Fig 1: Locating Crash Pad Side Cover
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the fuse box cover (A).

Fig 2: Locating Fuse Box Cover
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws and bolt, then remove the crash pad lower panel (A).

Fig 3: Locating Crash Pad Lower Panel With Mounting Screws And Bolt
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors (A) and diagnosis connector (B).

Fig 4: Locating Diagnosis Connector And Connectors
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damage clips.