Crash Pad Center Panel Replacement

CAUTION:

A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.

Remove the following items:
- Floor console assembly
  (Refer to "CONSOLE ")
- Crash pad side cover [LH, RH]
- Crash pad lower panel
- Glove box & Glove box housing
- Heater control unit
Using a screwdriver or remover, remove the crash pad center panel (A).

Fig 1: Locating Crash Pad Center Panel
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors (A).

Fig 2: Locating Crash Pad Center Panel Connectors
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damage clips.