Control Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF" & Disconnect Injector connector.
- Ignition "ON"
- Measure voltage between Pin No. 1 (Low side) terminal of main harness connector and chassis ground.
Measure voltage between Pin No. 2 (High side) terminal of main harness connector and chassis ground.
Specification:
Injector #1 (High side) - Approx 0.6V
Injector #1 (Low side) - Approx 0V
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.