Control Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF"
- Disconnect FPR connector.
- Ignition "ON" & ENG "OFF"
- Measure voltage between Pin No. 1 (Low Control), Pin No. 2 (High Control) terminal of FPR harness connector and chassis ground.
Specification:
FPR Low Terminal: Approx. 0V
FPR High Terminal: Approx. 0.8V
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.