DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
Case 1	DTC Strategy	Rationality check	Poor connection AATS
	Enable Conditions	Vehicle speed is greater than 40km/h Mass air flow is greater than 40kg/h and less than 60~220kg/h ECT is greater than 60 °C (140 °F) Duration of NO fuel cut off is greater than 50s
	Threshold Value	Absolute difference between of modeled AAT and AAT is greater than 20 °C (68 °F)
	Diagnostic Time	5s
Case 2	DTC Strategy	Plausibility check Monitor at cold condition
	Enable Conditions	Soaking time engine stop ECT 0 °C (32 °F) is greater than 5hr Soaking time engine stop ECT 90 °C (194 °F) is greater than 7hr Block heater not detected ECT less than 50 °C (122 °F) Absolute difference between of ECT at start and ECT is less than -3 ° C (26.6 °F) 30s after engine start
	Threshold Value	Difference between of Ref. Temp and AAT (at cranking) is greater than 20 °C (68 °F) * Ref. Temp: 2 of 3 signals are selected and averaged, and the other signal which has the biggest deviation is excluded
	Diagnostic Time	5s
MIL ON Condition		3 driving cycles