DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| Case 1 |
DTC Strategy |
|
- Poor connection
- Open or short in signal circuit
- ABS (ESC/ESP) Module
|
| Enable Conditions |
- Pin voltage input level = high level
- Turbine speed/Eng. speed ratio > 0.8
- Brake status: Brake pedal not pressed
|
| Threshold Value |
- Time period greater than 0.7s
|
| Diagnostic Time |
|
| Case 2 |
DTC Strategy |
|
| Enable Conditions |
- Pin voltage input level = low level
- Turbine speed/Eng. speed ratio > 0.8
- Brake status: Brake pedal not pressed
|
| Threshold Value |
- Time period greater than 0.7s
|
| Diagnostic Time |
|
| Case 3 |
DTC Strategy |
|
| Enable Conditions |
- Sensor signal no error (signal input from CAN or HW)
|
| Threshold Value |
- Vehicle speed greater than 273km/h (170mph)
|
| Diagnostic Time |
|
| Item |
Detecting Condition |
Possible Cause |
| Case 4 |
DTC Strategy |
|
- Poor connection
- Open or short in signal circuit
- ABS (ESC/ESP) Module
|
| Enable Conditions |
- Sensor signal no error (signal input from CAN or HW)
|
| Threshold Value |
- Vehicle speed less than 0km/h (0mph)
|
| Diagnostic Time |
|
| Case 5 |
DTC Strategy |
- Plausibility check in overrun
|
| Enable Conditions |
- Engine speed greater than 1000RPM and less than 4520RPM
- Fuel system status: Fuel cut off
|
| Threshold Value |
- Vehicle speed less than 3.8km/h (2.4mph)
|
| Diagnostic Time |
|
| Case 6 |
DTC Strategy |
|
| Enable Conditions |
- Vehicle speed greater than 0 and less than 326km/h (203mph)
|
| Threshold Value |
- Signal change per 10ms No change
|
| Diagnostic Time |
|
| MIL ON Condition |
|